Table of Contents
Advertisement
Installation of control board:
The assembly instructions assume that there
is no control board pre-installed.
General steps:
1. Remove cover of operator
2. Remove control board box cover
3.
Compare general pre-assembly of
control board
•
Picture 1: 230Volt 1-Phase motor
assembly
•
Picture 2: 400Volt 3-Phase motor
with motor protection switch
installed
4. Install the control board holders
•
4 pieces into the marked holes
•
See picture 3
Pic. 3
Pic. 1
Pic. 2
Advertisement
Table of Contents
