Honda VT750C Owner's Manual page 83

07/08/01 19:09:33 32MEG630_083
3. Apply a thin coat of engine oil to the new
oil filter rubber seal ( ).
4. Using a special tool and a torque wrench,
install the new oil filter and tighten to a
torque of:
26 N·m (2.7 kgf·m , 19 lbf·ft)
Use only the Honda genuine oil filter or a
filter of equivalent quality specified for your
model. Using the wrong Honda filter or a
non-Honda filter which is not of equivalent
quality may cause engine damage.
(4)
(4) Oil filter rubber seal
5. Check that the sealing washer on the
4 drain plug is in good condition and install
the plug. Replace the sealing washer
every other time the oil is changed, or
each time if necessary.
Engine oil drain plug torque:
29 N·m (3.0 kgf·m , 21 lbf·ft)
6. Fill the crankcase with the recommended
grade oil; approximately:
2.6 (2.7 US qt , 2.3 Imp qt)
7. Install the oil filler cap/dipstick.
8. Start the engine and let it idle for 3 5
minutes.
9.
2 3 minutes after stopping the engine,
check that the oil level is at the upper
level mark on the oil filler cap/dipstick
with the motorcycle upright on firm, level
ground. Make sure there are no oil leaks.
73