Honda VT750C Owner's Manual page 100

07/08/01 19:11:49 32MEG630_100
12. While holding the other end of the rear
axle shaft ( ) with a wrench, remove the 18
rear axle nut ( ). 19
13. Pull the rear axle shaft out and remove
the side collar.
14. Move the wheel to the right to separate it
from the final drive gear case.
15. Remove the rear wheel.
(19)
(19) Rear axle nut
90
Installation Notes:
Reverse the removal procedure.
Before installing the rear wheel, check
that the wheel hub and final drive gear
splines are coated with grease.
Be sure the splines on the wheel hub fit
into the final gear case.
Used cotter pins may not effectively
secure fasteners. Always replace used
cotter pins with new ones.
Before installing the muffler, replace the
muffler gasket with a new gasket.