Mellanox Technologies IS5025D-1BRC User Manual page 50

Rev 3.4
5. If the switch comes on, Use the FabricIT management CLI or Web GUI to determine the
cause of the Shutdown.
6. Check the temperature.
7. Check the Fan status.
The switch is not working and unresponsive:
1. Reset the switch.
If resetting the switch does not work:
1. Unplug the switch.
2. Wait 5 minutes.
3. Plug in the switch.
4. If the switch does not come on, check the power supplies.
5. If the switch comes on, use the FabricIT management CLI or Web GUI to determine the cause
of the shutdown.
The last software update did not succeed:
1. Connect the RS232 connector (CONSOLE) to a laptop.
2. Push the reset button on the switch or management module.
3. You will have ~ 5 seconds to stop the U-Boot by pressing Control-B.
4. Choose the image to upload. Only use image 1 or image 2.
U-Boot 2009.01-mlnx1.4 (May 12 2010 - 14:08:15)
CPU:
MHz)
Security/Kasumi support
Bootstrap Option H - Boot ROM Location I2C (Addr 0x52)
Internal PCI arbiter disabled
32 kB I-Cache 32 kB D-Cache
Board: Mellanox PPC460EX Board
FDEF: No
I2C:
DRAM:
FLASH: 16 MB
NAND: 1024 MiB
PCI:
PCIE0: link is not up.
PCIE1: successfully set as root-complex
01 00 15b3 bd34 0c06 00
Net:
Hit Ctrl+B to stop autoboot: 0
Mellanox FabricIT
Boot Menu:
1. EFM_PPC_M460EX EFM_1.1.1000 2010-06-24 16:32:03 ppc
2. EFM_PPC_M460EX EFM_1.1.1200 2010-06-25 18 :00:03 ppc
3. U-Boot prompt
Choice:
50 Mellanox Technologies
AMCC PowerPC 460EX Rev. A at 1000 MHz (PLB=200, OPB=100, EBC=100
ready
2 GB (ECC enabled, 400 MHz, CL3)
Bus Dev VenId DevId Class Int
ppc_4xx_eth0, ppc_4xx_eth1
Troubleshooting