Topcom BABYTALKER 3000 SEDS User Manual page 6

and that the polarity matches the illustration (B)! Carefully close the battery compartment and rotate the
belt clip back downward.
8.5 Charging rechargeable batteries in the parent unit
– Insert the small plug from the AC mains adapter into the mains power
socket on the charging station
mains socket (230 V / 50 Hz).
– Place the parent unit in the charging station. The red charging LED
will light up.
• It takes around 10 hours to fully charge the batteries.
• The red On/Off LED
exhausted. Recharge the batteries.
9 Operation and use
9.1 Switching the baby unit and parent unit on and off
– Press the On/Off switch
and the link LED
– Press the On/Off switch
• The parent unit will attempt to connect to the baby unit. Once the Link LED
unit lights up continuously, it means that the connection has been made successfully. If it
does not, see page 8.
– Press and hold the On/Off switch
go out.
– Press and hold the On/Off switch
On/Off LED 2
9.2 Testing the link between the parent and baby units
You must check the wireless link when you use the baby monitor for the first time.
– Put the parent unit in the same room as the baby unit, but position them at least 2 metres apart.
– Switch on both units. The parent unit will attempt to connect to the baby unit.
– The green link LED
The LED stays on continuously once a connection has been made.
13
– The sounds picked up by the microphone
– The playback volume is indicated by the volume LEDs
The higher the volume, the more LEDs will light up.
– Reduce the distance between the parent and baby units until they re-connect.
9.3 Finding the parent unit
– Press the paging button
– In response, the parent unit will emit a high-pitched tone for 30 seconds. This makes it easier to find the
parent unit.
– Briefly press the On /Off switch
9.4 Setting the SEDS
The Babytalker 3000 SEDS is based on the unique SEDS (Smart ECO Distance
Switch) technology, which enables parents to set the power radiated by the
equipment themselves. This gives them a choice of 'long distance mode' or 'ECO'
mode with reduced power consumption and lower radiation.
Set switch to:
10
– 'LONG' for a maximum range of 600 m (clear space).
– 'ECO' to reduce the radiated power by half and reduce power consumption at the same time. With this
setting the range is reduced to a maximum of 300 m (clear space).
6
and plug the AC mains adapter into a
18
will flash once the battery pack is
17
in order to switch on the parent unit. The On/Off LED
15
will start flashing.
13
in order to switch on the baby unit. The On/Off LED
4
15
4
goes out.
on the parent unit flashes while it is trying to connect.
13
on the baby unit and hold it for at least 2 seconds before releasing it.
5
on the parent unit to switch off the tone.
15
in order to switch off the parent unit. The On/Off LED
in order to switch off the baby unit press and hold it until the
are reproduced by the parent unit.
6
at the top of the parent unit.
11
Babytalker 3000 SEDS
19
will light up
17
2 will light up.
on the parent
2
SEDS
10
will
17
LONG
ECO