Menu Selection Details - Yaesu FT-2600M Operating Manual

ltem # Menu ltem
PG AC Programming the function assigned to microphone
21
k ey ACC
22 RFSQL Adjust the RF Squelch threshold level
23 RPTR Setting of the Repeater Shift Direction
24 RVRT Enable/Disable the "Priority Channel Revert" feature
25 SCAN Select the Scan Resume mode
SHIFT Set the magnitude of the Repeater Shift
26
SKIP Enable/Disable Skipping of a channel during
27
scanning
28 SQL Set the Squelch threshold
STEP Setting of the synthesizer steps used in VFO or
29
Memory Tune operation
30 TONE Select the CTCSS or DCS mode
31 TONEF Setting of the CTCSS Tone Frequency
32 TOT Set the time-out limit for the Time-Out Timer
W/N Reduction of the Microphone Gain/Deviation and
33
receiver bandwidth
01 ALPH
Function:
02 APO
Function:
Available Values:
Default Setting:
03 ARTS
Function:
Available Values:
Default Setting:
04 BEEP
Function:
Available Values:
Default Setting:
05 BELL
Function:
Available Values:
Default Setting:
FT-2600M O
PERATING
Function
M S
ENU ELECTION
Programming an Alpha/Numeric label for a memory. See page 32.
Enable/Disable the Automatic Power Off feature.
1 ~ 12 Hours, or OFF
OFF
Select the ARTS mode.
TRX/TX/RX/OFF
OFF
Enable/Disable the key/button beeper.
ON/OFF
ON
Enable/Disable the CTCSS Bell Paging feature.
ON/OFF
OFF
M
ANUAL
Menu System
Available Values
SQL OFF/SSRCH/TONE/
TSRCH/T_BURST/RPTR
OFF/S-3/S-5/S-7/S-9/S-FULL
ARS/Shift -/Shift +/OFF
OFF/ON
BUSY/TIME
0.00 ~ 99.95 MHz
±
(only 4 MHz will work)
SKIP/STOP
OFF/1 ~ 15
5/10/12.5/15/20/25/50 kHz per
step
OFF, ENC, ENC/DEC, DCS
47 standard CTCSS Tones
1 ~ 60 minutes, or OFF
WIDE/NARROW
D
ETAILS
D efault
TSRCH
OFF
ARS
OFF
BUSY
600 kHz
STOP
8
5 kHz
OFF
100.0 Hz
6 minutes
WIDE
51