Yaesu FT-2600M Operating Manual page 28

Operation
m "DCS" (digital code squelch) appears when Digital Code Squelch system (TX &
RX) is active.
(3) Press and hold in the [MHz] key for one second to save the new setting and exit to
normal operation.
Now that you have selected the Tone Mode to be used, you need to select the CTCSS tone,
or DCS code, that you and the other station have both agreed to use:
m If "ENC" or "ENC/DEC" is selected:
(1) Press and hold in the [MHz] key for one second, then rotate the Main Dial knob to
select "31 TONEF."
(2) Press the [MHz] key, then rotate the Main Dial knob to choose the desired CTCSS
tone.
(3) Press and hold in the [MHz] key for one second to save the new setting and exit to
normal operation.
m If "DCS" is selected:
(1) Press and hold in the [MHz] key for one second, then rotate the Main Dial knob to
select "10 DCSN."
(2) Press the [MHz] key, then rotate the Main Dial knob to choose the desired DCS
code.
(3) Press and hold in the [MHz] key for one second to save the new setting and exit to
normal operation.
CTCSS/DCS settings may stored in any memory register at the time of frequency program-
ming. To change a memorized tone/code or tone system, just recall the memory channel, reset
the tone or function, and store the memory again. If you activate CTCSS/DCS on a PMS
memory, it will be active when that memory pair is used to start PMS scanning or tuning.
023 025 026 031 032 036 043 047 051 053 054 065 071 072 073 074 114 115 116 122 125
131 132 134 143 145 152 155 156 162 165 172 174 205 212 223 225 226 243 244 245 246
251 252 255 261 263 265 266 271 274 306 311 315 325 331 332 343 346 351 356 364 365
371 411 412 413 423 431 432 445 446 452 454 455 462 464 465 466 503 506 516 523 526
532 546 565 606 612 624 627 631 632 654 662 664 703 712 723 731 732 734 743 754
26
DCS C ODES
FT-2600M O
-
M
PERATING ANUAL