Power Output Setting; Ptt Locking - Yaesu FT-2600M Operating Manual

Operation
P O S
OWER UTPUT
Four power output levels are available on this transceiver: 5 watts (Low 3), 10 watts (Low 2),
25 watts (Low 1) and 60 watts (High).
To change the power level, press and hold the [REV] key to select one of four power
setting. These power levels will be stored in memory registers, at the time of memory
storage (see page 32 for details on Memory operation).
During transmission, the Bar Graph will deflect in the display, according to the power
output selected.
5 watts (Low 3)
25 watts (Low 1)
PTT L
OCKING
The PTT circuitry may be locked out, so as to prevent unauthorized (or otherwise undes-
ired) transmission.
To lock out the PTT switch and prevent transmission, use the following procedure:
(1) Press and hold the [MHz] key for one second, then rotate the Main Dial knob to select
"16 LCKTX."
(2) Press the [MHz] key, then rotate the Main Dial knob to select the display to "ON."
(3) Press and hold the [MHz] key for one second to save the new setting and exit to
normal operation.
(4) To cancel PTT locking, select "OFF" in step (2) above.
20
ETTING
10 watts (Low 2)
60 watts (High)
FT-2600M O M
PERATING ANUAL