Inserting And Removing The Sfp Module Patch Cable - Cisco CGS 2520 Hardware Installation Manual

Chapter 2 Switch Installation
Figure 2-18
Grasp the SFP module, and carefully remove it from the slot.
Step 5
Place the module in an anti-static bag or other protective environment.
Step 6

Inserting and Removing the SFP Module Patch Cable

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 1
Insert the SFP module patch cable into the slot until you feel the connector on the cable snap into place
Step 2
at the rear of the slot (see
Figure 2-19
Repeat these steps for the second switch that you want to connect to the first switch.
Step 3
OL-31444-01
Removing a Bale Clasp Latch SFP Module
Figure 2-19).
Inserting an SFP Module Patch Cable
Inserting and Removing the SFP Module Patch Cable
Cisco CGS 2520 Hardware Installation Guide
2-21