Appendix; Configuring The Switch With The Cli Setup Program; Accessing The Cli Through The Console Port; Console Port - Cisco CGS 2520 Hardware Installation Manual

Configuring the Switch with the CLI Setup
Program
This appendix provides a command-line interface (CLI) setup procedure for a standalone switch. To set
up the switch by using Express Setup, see the Cisco CGS 2520 Getting Started Guide. Before connecting
the switch to a power source, review the safety warnings in the
and the

Accessing the CLI Through the Console Port

You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access
the CLI:
•
•
RJ-45 Console Port
Step 1 Connect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC. Connect the other end of the
cable to the switch console port.
Step 2 Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC
application such as HyperTerminal or ProcommPlus, makes communication between the switch and
your PC or terminal possible.
OL-31444-01
"Power Supply Module Installation" section on page
RJ-45 Console Port, page C-1
USB Console Port, page C-3
A P P E N D I X
"Switch Installation" section on page 2-1
3-2.
Cisco CGS 2520 Hardware Installation Guide
C
C-1