Wall-Mounting; Attaching Brackets For Wall Mounting - Cisco CGS 2520 Hardware Installation Manual

Installing the Switch

Wall-Mounting

The following steps are covered in this section:
•
•
If the switch is wall-mounted in an enclosure allow for these minimum clearances:
Warning
• Sides of switch (facing up and facing down): 3.75 in. (9.52 cm)
• Port side 3.0 in. (7.62 cm)
• Power supply side: 5.25 in. (13.33 cm)
• Cover side (side not facing wall): 1.75 in. (4.44 cm)
• Base side (facing wall): 0 in. (0 cm)

Attaching Brackets for Wall Mounting

Follow these steps to mount the switch onto a wall.
Insert the rubber plugs into the appropriate holes. Follow the same procedure for the other side of the
Step 1
switch.
Use a screwdriver or pen to completely push in the rubber plugs (see
Step 2
Install the brackets onto both sides of the switch (see
Step 3
Secure the bracket and switch to the wall using the screws provided.
Step 4
Figure 2-14
Cisco CGS 2520 Hardware Installation Guide
2-16
Attaching Brackets for Wall Mounting, page 2-16
Wall-Mounting (for IP-30 Compliance), page 2-17
shows how to wall-mount the switch onto a wall.
Chapter 2
Figure 2-8).
Figure 2-16).
Switch Installation
OL-31444-01