Attaching Brackets For Etsi Racks - Cisco CGS 2520 Hardware Installation Manual

Chapter 2 Switch Installation
Figure 2-11
1
2
For IP-30 compliance: If you use 23-inch brackets, you can insert the rubber plugs in the same holes as
Note
shown in

Attaching Brackets for ETSI Racks

Figure 2-12
mounting onto an ETSI rack.
OL-31444-01
Attaching Brackets for 23-Inch Racks
Phillips flat-head screws
Cable-side-mounting position
Figure 2-7 or Figure 2-8
shows the mounting bracket locations on the switch for cable-side mounting and power-side
3 Power supply-side mounting position
before installing the brackets.
Cisco CGS 2520 Hardware Installation Guide
Installing the Switch
2-13