Table of Contents
Advertisement
Switch Installation
Figure 32: Installing an SFP Module
Removing an SFP Module
Procedure
Step 1
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2
Disconnect the cable from the SFP module. For reattachment, note which cable connector plug is send (TX)
and which is receive (RX).
Step 3
Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 4
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the latch is obstructed
and you cannot use your finger, use a small, flat-blade screwdriver or other long, narrow instrument to open
the latch.
Step 5
Grasp the SFP module, and carefully remove it from the module slot.
Step 6
Place the module in an antistatic bag or other protective environment.
10/100/1000 PoE and PoE+Port Connections
The ports provide PoE support for devices compliant with IEEE 802.3af and 802.3at (PoE+), and also provide
Cisco prestandard PoE support for Cisco IP Phones and Cisco Aironet Access Points.
Cisco Catalyst 1000 Series 8-Port and 16-Port Switch Hardware Installation Guide
Removing an SFP Module
37
Hide quick links:
Advertisement
Table of Contents
