Turning A Talk Group Id List On Or Off; Scanning The Talk Group Id Lists; Priority Scanning Talk Group Ids - Radio Shack 20-162 User Manual

Once talk group IDs are stored in list, you can
scan them like you scan conventional frequencies.

Turning a Talk Group ID List On or Off

1. Press ENT/PGM then TRUNK/MODE to enter
the ID Programming Mode.
2. Repeatedly press TRUNK to select the
desired ID List.
3. Press FUNC then 1 to turn the ID List on or off.

Scanning the Talk Group ID Lists

Press SCAN to begin scanning the lists you have
stored.
In Close Mode, you can remove or restore a
talk group ID list from active scanning. While
the scanner is stopped on a voice channel
transmission, press the number (0-9) of the list you
desire to turn on or off.
Note: One of the ten scan lists must
always be active. You cannot remove all
of them.

Priority Scanning Talk Group IDs

You can assign a priority to a favorite ID so
during scanning the scanner checks that ID more
frequently than the others in the list. Each of the
ten memory locations reserved for storing lists can
have only one priority ID, and the ID assigned that
priority in List 1 has the highest priority of all.
To assign a priority to an ID, press and hold PRI for
2 seconds in ID Programming Mode. "P" appears.
M
57
Trunk Scanning