Table of Contents
Advertisement
Trunk Scanning
group IDs for each trunking bank. If you use all the banks as trunking banks,
2000 talk group IDs will be available.
Once talk group IDs are stored in list, you can scan them like you scan
conventional frequencies.
Turning a Talk Group ID List On or Off
1. Press ENT/PGM then TRUNK/MODE to enter the ID Programming Mode.
2. Repeatedly press TRUNK to select the desired ID List.
3. Press FUNC then 1 to turn the ID List on or off.
Scanning the Talk Group ID Lists
Press SCAN to begin scanning the lists you have stored.
In Close Mode, you can remove or restore a talk group ID list from active
scanning. While the scanner is stopped on a voice channel transmission,
press the number (0-9) of the list you desire to turn on or off.
M
Note: One of the ten scan lists must always be active. You cannot
remove all of them.
Priority Scanning Talk Group IDs
You can assign a priority to a favorite ID so during scanning the scanner
checks that ID more frequently than the others in the list. Each of the ten
memory locations reserved for storing lists can have only one priority ID, and
the ID assigned that priority in List 1 has the highest priority of all.
To assign a priority to an ID, press and hold PRI for 2 seconds in ID
Programming Mode. "P" appears.
To turn priority ID scanning on or off, press PRI during ID while scanning in
Close Mode. "PRI" appears when priority scanning is turned on.
Note: Priority ID scanning does not operate when priority IDs are
locked out. See "Locking Out Talk Group IDs" on p. 45.
50
Motorola Trunking Systems
Motorola Type II 800 MHz
On the 800 MHz trunking band, you can select the channel plan (Normal,
Splinter, or Custom). On the 900 MHz trunking band, you do not need to set
any other settings.
Follow these steps to program 800 MHz band Motorola trunking.
1. Press ENT/PGM then TRUNK/MODE to enter the ID Programming Mode.
2.
Press FUNC +
or
to select the desired bank.
3. Repeatedly press FUNC + TRUNK/MODE and select MOT Mode.
4. Press FUNC + 3.
5. Select NORMAL, SPLINTER or CUSTOM and press ENT/PGM.
•
If you are uncertain about the channel plan, use the default setting
of Normal. The base frequency in Normal is 851.0125 MHz.
•
If you cannot receive with the normal setting, change to SPLINTER.
The base frequency in Splinter is 851.0000 MHz.
•
If you cannot receive in either the Normal or Splinter channel plans,
try Custom. In the Custom channel plan, you can set the base
frequency, offset channel and spacing for 800MHz Trunking System.
Setting the Base Frequency, Offset Channel, and Spacing for 800 MHz
Custom
To properly track Motorola 800 MHz Custom trunked systems, you must enter
the base frequency, offset channel and spacing for each system.
1. Press FUNC + MAN/MENU to enter the Menu Mode.
2. Select Trunk Option press ENT/PGM.
3. Select the desired bank and press ENT/PGM.
4. Select MOT, and press ENT/PGM.
5. Select 800MHz CH Plan, and press ENT/PGM.
6. Select Custom, and press ENT/PGM.
7. Select Custom Range, and press ENT/PGM.
8. Select Base Freq, and press ENT/PGM.
9.
Use the number keys and • to enter a Lower Frequency, then press ENT/PGM.
Trunk Scanning
51
Advertisement
Table of Contents
