Grandstream Networks HandyTone-486 User Manual page 20

Analog telephone adaptor
Hide thumbs Also See for HandyTone-486:
Table of Contents

Advertisement

HandyTone-486 User Manual
Use DNS SRV:
User ID is Phone
Number
SIP Registration
Unregister on
Reboot
Register
Expiration
Early Dial
Dial Plan Prefix
No Key Entry
timeout
Use # as
Send Key
Local SIP port
Local RTP port
Use Random Port This parameter, when set to Yes, will force random generation of both
Default is No. If set to Yes the
If the HandyTone ATA has an assigned PSTN telephone number,
then this field will be set to "Yes". Otherwise, set it to "No". If
"Yes" is set, a "user=phone" parameter will be attached to the
"From" header in SIP request
This parameter controls whether the HandyTone ATA needs to send
REGISTER messages to the proxy server. The default setting is "Yes".
Default is No. If set to yes, the SIP user will be unregistered on reboot.
This parameter allows the user to specify the time frequency (in
minutes) the HandyTone ATA will refresh its registration with the
specified registrar. The default interval is 60 minutes (or 1 hour). The
maximum interval is 65535 minutes (about 45 days).
Default is No. Use only if proxy supports 484 response
Sets the prefix added to each dialed number
Default is 4 seconds.
This parameter allows the user to configure the "#" key to be used as
the "Send"(or "Dial") key. Once set to "Yes", pressing this key will
immediately trigger the sending of dialed string collected so far. In this
case, this key is essentially equivalent to the "(Re)Dial" key. If set to
"No", this # key will then be included as part of the dial string to be sent
out.
This parameter defines the local SIP port the HandyTone ATA will listen
and transmit on. The default value is 5060.
This parameter defines the local RTP-RTCP port pair the HandyTone
ATA will listen and transmit on. It is the base RTP port for channel 0.
When configured, channel 0 will use this port_value for RTP and the
port_value+1 for its RTCP; channel 1 will use port_value+2 for RTP and
port_value+3 for its RTCP. The default value is 5004.
the local SIP and RTP ports. This is usually necessary when multiple
HandyTone ATAs are behind the same NAT.
20
Grandstream Networks, Inc.

Advertisement

Table of Contents
loading

Table of Contents