Configure Your Ata; Five Easy Steps To Configure The Ht-502; Figure 2: Configuring The Ht-502; Table 2: Definitions Of The Ht-502 Led S - Grandstream Networks HT– 502 User Manual

T 2: D
ABLE EFINITIONS OF THE
Power LED
WAN LED
LAN LED
PHONE1 /
PHONE2 LED
NOTE: All LEDs display green when ON. Slow blinking of Power, WAN and LAN LED together indicate
the product in firmware upgrading or provision stat
C Y ATA
ONFIGURE OUR
The HT–502 is easy to configure using the embedded GUI pages and the following five (5) steps.
F C
IVE EASY STEPS TO ONFIGURE THE
1. Connect a standard touch-tone analog telephone (or fax machine) to first FXS port.
2. Connect another standard touch-tone analog telephone (or fax machine) to second FXS port.
3. Insert the Ethernet cable into the WAN port of HT–502 and connect the other end of the Ethernet cable
to an uplink port (a router or a modem, etc.)
4. Connect a PC to the LAN port of HT–502.
5. Insert the power adapter into the HT–502 and connect it to a wall outlet.
F 2: C
IGURE ONFIGURING THE
Analog Phone
Cordless
Phone
Fax
z
Grandstream Networks, Inc.
HT–502 LED
S
Indicates Power. Remains ON when Power is connected and turned ON.
Indicates LAN (or WAN) port activity.
Indicates PC (or LAN) port activity.
Indicate status of the respective FXS Ports-PHONE1 / PHONE2 on the back
panel
Busy – ON (Solid Green)
Available – OFF
Slow blinking FXS LEDs indicates voicemail for that port.
HT–502
HT–502
FXS
HT-502 User Manual
Firmware 1.0.0.39
e
Internet
ADSL/Cable
Modem Ethernet
WAN
FXS
LAN
Analog Phone
Cordless
Phone
Fax
Page 6 of 35
Last Updated: 03/2007