Table of Contents
Advertisement
1 4 .
1 4 .
1 4 .
1 4 .
1 4 . ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1)
ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1)
ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1)
ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1)
ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1)
These connectors are for ATX power supply plugs. The power supply
plugs are designed to fit these connectors in only one orientation.
Find the proper orientation and push down firmly until the connectors
completely fit.
•
•
•
•
•
•
P5AD2 Deluxe ATX power connectors
2 - 3 0
2 - 3 0
2 - 3 0
2 - 3 0
2 - 3 0
Use of an ATX 12 V Specification 2.0 -compliant power supply unit
(PSU) that provides a minimum power of 350 W is recommended
for a fully-configured system.
Do not forget to connect the 4-pin ATX +12 V power plug;
otherwise, the system will not boot up.
Use of a PSU with a higher power output is recommended when
configuring a system with more power consuming devices. The
system may become unstableor may not boot up if the power is
inadequate.
When using an ATX 12 V PSU with a 20-pin power plug, make sure
that it can provide at least 15 A on the +12 V lead, and a minimum
power of 350 W. Use of an ATX 12 V PSU with a 20-pin power plug
is not recommended.
The ATX 12 V Specification 2.0-compliant (350 W) PSU passed the
motherboard power requirement test with the following configuration:
CPU
Memory
Graphics card
Parallel ATA devices :
Serial ATA device
Optical drives
SCSI devices
You must install a PSU with a higher power rating if you intend to
install additional devices.
P5AD2
:
Intel
®
Pentium
®
4 3.6 GHz
:
512 MB DDR2 (x 4)
:
PCI Express x16 Nvidia EN5900
IDE hard disk drive (x 2)
:
SATA hard disk drive
:
CD-ROM (x 2)
:
SCSI card and SCSI hard disk drive
ATX12V1
GND
+12V DC
+5V Standby
GND
+12V DC
Power OK
C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n
C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n
C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n
C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n
C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n
EATXPWR1
+3 Volts
Ground
+12 Volts
+5 Volts
+12 Volts
+5 Volts
+5 Volts
-5 Volts
Ground
Ground
+5 Volts
Ground
Ground
Ground
+5 Volts
PSON#
Ground
Ground
+3 Volts
-12 Volts
+3 Volts
+3 Volts
Advertisement
Table of Contents
