Set Supervisor Password; Set User Password; Save & Exit Setup; Exit Without Saving - AOpen I975XA-YDG Manual

Set Supervisor Password

Supervisor Password prevents unauthorized use of your computer. If you set a
password, the system prompts for the correct password before boot or access to
Setup.
To set a password:
1. At the prompt, type your password. Your password can be up to 8
alphanumeric characters. When you type the characters, they appear as
asterisks on the password screen box.
2. After typing the password, press.
3. At the next prompt, re-type your password and press again to confirm the
new password. After the password entry, the screen automatically reverts to
the main screen.
To disable the password, press "Enter" when being prompted to enter the
password. The screen displays a message confirming that the password has been
disabled.

Set User Password

User Password can authorize users check only. It cannot modify the BIOS setting
inside.
To set a password:
1. At the prompt, type your password. Your password can be up to 8
alphanumeric characters. When you type the characters, they appear as
asterisks on the password screen box.
2. After typing the password, press.
3. At the next prompt, re-type your password and press again to confirm the
new password. After the password entry, the screen automatically reverts to
the main screen.
To disable the password, press "Enter" when being prompted to enter the
password. The screen displays a message confirming that the password has been
disabled.
Save & Exit Setup
This function automatically saves all CMOS values before leaving Setup.

Exit without Saving

Use this function to exit Setup without saving the CMOS value changes. Do not
use this option if you want to save the new configuration.
69