Connecting Front Panel Cable - AOpen I975XA-YDG Manual

Connecting Front Panel Cable

Attach the power LED, speaker and reset switch connectors to the corresponding
pins. If you enable "Suspend Mode" item in BIOS Setup, the ACPI & Power LED
will keep flashing while the system is in suspend mode.
Locate the power switch cable from your housing, which is a 2-pin female
connector from the housing front panel. Plug this connector to the soft-power
switch connector marked SPWR.
1
Power Switch
NC
GND
NC
Power LED-
+5V
GND
HDD LED
Power LED+
HDD LED
NC
+5V
+5V GND
GND
GND
NC RESET
SPEAKER
GND
Front Panel Connector
20