AOpen I975XA-YDG Manual page 52

Standard CMOS features > IDE Channel 0 Master > IDE HDD
Auto-Detection
Press "Enter" to auto-detect parameters of HDD
Standard CMOS features > IDE Channel 0 Master > IDE Channel 0 Master
(Slave)
Define the parameters of IDE devices in Channel 0 (Master or Slave). Available
options:
None: if there is no device, please select "None" for speeding boot up.
Auto: enable BIOS to auto-detect parameters of IDE device. (Default)
Manual: allow users to define parameter of IDE device.
Standard CMOS features > IDE Channel 0 Master > Access Mode
Set the using mode of HDD. Available options: CHS / LBA / Large / Auto
(default). User can select the mode according to the label on HDD.
Cylinder: Enter cylinder number
Head: Enter head number
Precomp: Write precompensation
Landing Zone: Location of head
Sector: Sector Number
Standard CMOS features > Drive A
This item allows user select the floppy drive type. Available items: None / 360KB
5.25" / 1.2MB 5.25" / 720KB 3.5" / 1.44MB 3.5" / 2.88MB 3.5"
Standard CMOS features > HaltOn
This parameter enables you to control the system stops in case of Power-On Self
Test (POST) error. Available items: No errors / All errors / All, But Keyboard
/ All, But Diskette / All, But Disk/Key
52