Paper Loading Path; Journal Paper Loading - Toshiba 4610 SureMark User Manual

Thermal
Platen
Paper Roll
Paper
Roll Core
Figure 2-7. Paper Loading Path
4. Place the leading edge of the paper over the metal guide as shown in
5. Close the paper cover.
6. Press the customer receipt feed button to advance the paper and to verify that
Attention:
cover closed because this disengages the paper feed. Then the paper feed motor
must catch up before the printer can feed the paper, which causes missing lines or
partial lines of print. Use the customer receipt feed button to advance the receipt
and then all lines will print.

Journal paper loading

1. Open the journal station cover.
2. If there is any unused paper or if there is an empty paper roll core in the paper
3. Place the paper roll into the paper roll bucket. The leading edge of the paper
4. Place the leading edge of the paper over the metal and plastic shelf.
5. Insert the paper into the two halves of the plastic paper receiver. Turn the roll to
6. Close the journal station cover.
2-6
4610 SureMark Three– Station Printer: User's Guide
Figure 2-7.
the paper is feeding correctly. Feed 30 cm (about 1 ft) of paper through to test
for correct alignment.
Do not pull the receipt paper out of the printer with the paper access
roll bucket inside the printer, remove it before inserting a new paper roll. Discard
the empty paper roll core.
should come from the direction of the front of the printer and go across the top
of the roll. If it feeds from the bottom of the roll, nothing will be printed on the
paper.
Note: The thermal printhead will not print on paper with glue on it. If the new
paper roll was sealed by glue, tear off the 8 inches (29 cm) of paper with
glue on it before loading it.
wrap several inches of paper around the paper receiver.
Not Correct Correct