Ribbon Path Around The Printhead; Ribbon Loading - Toshiba 4610 SureMark User Manual

Ribbon loading

1. Open the ribbon cover. As the cover is opened, the printhead moves to a
2. If there is already a ribbon cartridge installed, remove it by lifting it straight up.
3. Maintain ribbon tension by turning the ribbon cartridge knob. Lower the cartridge
Ribbon Shield
Printhead
Figure 2-5. Ribbon Path around the Printhead
4. Close the ribbon cover.
2-4
4610 SureMark Three– Station Printer: User's Guide
position where you can easily load a ribbon.
Note: You might need to hold the body of the cartridge rather then the top to
remove it.
into position until the notches on its sides snap into place on the printer guides.
Once the cartridge is in place, turn the knob until the ribbon slides into place
between the printhead and the ribbon shield. See Figure 2-5 for correct ribbon
positioning.
Correct Not Correct