Control Panel And Knobs; Porcelain Enamel Cooktop; Painted Surfaces - Hotpoint RB754N Use & Care Manual

Control Panel and Knobs

it's a good idea to wipe the c{)ntrol panel after each use
Do not use abrasive cleansers, strong liquid
cleansers, plastic scouring pads or oven cleansers
on the control panel—they will damage the finish.
A 50/50" solution of vinegar and hot w~ter solution
Clear Groove in Stem

Porcelain Enamel Cooktop

The porcelain enamel finish is sturdy but
breakable if misused. This finish is ticid-resistant.
on the finish.
If acids spill on the cooktop while it is hot, use a dry
cleansing powders, Rinse well.
Lift-Up Cooktop
Clean the tireu under the cooktop
often. Built-up soil, especially
make
To
supported in the up position.

Painted Surfaces

Painted surftices include [he outside oven door, sides,
commercial oven cleaners, cleansing powders, steel
wool or harsh abrasives on any painted surface.
The control knobs may be removed for easier
cleaning. Before removing the knobs for cleaning,
please note that the knobs on the left side and the
When replacing the knobs. check the OFF
insure
in each side. The groove" on one side has a spring clip.
The other groove is clear (see illustration). Check the
inside oi. the knob and i.ind the molded rib. Replace
the knob by fitting the nl(~lded rib inside the knob into
the clear groove on the stem. Wash the knobs in soap
and water or a vinegar and hot water solution" but do
For other spills such as fat smatterings, wash with
soap and water or cleansing powders tifter the surface
Be sure all surface units are turned
Grasp the front sides of the cooktop
need to be removed before lifting.
After cleaning under the cooktop
with hot, mild soapy water and a
careful not to pinch your fingers.
Glass Surfaces
To clean the outside glass finish,
Rinse and
proper alignment. The knob stem has a groove
polish with a dry cloth. Do not allow the
Rods
use a gluss cle:lncr.
25