Connecting Combined Luminaires Side-To-Side - Philips Showline SL NITRO 510 Installation And User Manual

SL NITRO 510 LED STROBE Luminaire

Connecting Combined Luminaires Side-to-Side

When combining units connected side-to-side, all units connect using the same pin system and any combination can
be created (refer to installation instructions and warnings contained in
12).
• Each SL NITRO 510 LED STROBE Luminaire and SL BAR 520 RGBW Luminaire ships with three Luminaire
Connecting Pins as indicated in Figure 9.
• The three side-to-side pins must be installed per luminaire.
• All three pins are used to connect luminaires together linearly. Each fixture must be mounted using its own mount-
ing hardware. The side-to-side pins are only to align the luminaires and do not provide hanging support.
• Figure 12 shows an example of connecting luminaires side-by-side.
Front View
WARNING! Each fixture must use an approved safety cable attached to a fixed object.
Sh wline
Connecting Pin
SL NITRO 510 LED STROBE Luminaire
Note, all luminaires are sold separately.
Figure 12: Connecting Combined Luminaires Side-to-Side Example
"Connecting Luminaires Side-to-Side" on page
SL NITRO 510 LED STROBE Luminaire
SL BAR 520 LED Luminaire
SL BAR 520 LED Luminaire
Mounting SL NITRO 510 LED STROBE Luminaire with Other Luminaires
Installation & User's Manual
See Detail
Rear View
Connecting Pin (x2)
15