Zone Mapping Mode - Philips Showline SL NITRO 510 Installation And User Manual

Installation & User's Manual
4 Control Channel
5 Strobe Duration
6 Strobe Rate

5. Zone Mapping Mode

Table 15 on page 27 provides DMX channel mapping of all DMX512 control values when the SL NITRO 510 LED
STROBE Luminaire is in Zone Mapping DMX512 mode (as set by the luminaire's menu system). Figure 16
indicates each Zone in relationship to the front of the luminaire.
Front of Luminaire
Note: For DMX Channel Mapping (Zone Mapping Mode), refer to Table 15 on page 27.
2 6
DMX CONTROL
Table 14: DMX Channel Mapping (16-bit Control Mode)
0 - 255 0 - 100%
0 - 255 0 - 100%
0 - 255 0 - 100%
Zone 1
Zone 4
Note, this is a graphical representation for Zone identification purposes only.
Figure 16: SL NITRO 510 LED STROBE Luminaire Zones
SL NITRO 510 LED STROBE Luminaire
0
0
0
Top of Luminaire
Zone 2
Zone 5
Bottom of Luminaire
Control channel operation. Set control channel
value to desired action, hold value for at least 5
seconds, then turn to 0. Set control channel
value to 0 without any scaling.
Default Setting on Console = DMX 0-4
Dimming Curve_linear = DMX 30 - 34
Dimming Curve_Square = DMX 35- 39
Dimming Curve_S-Curve = DMX 40 - 44
Dimming Curve_PL-Curve = DMX 45 - 49
Fan_Auto = DMX 80 - 84
Fan_Off = DMX 85 - 89
Not Used = DMX 105 - 250 (Reserved for future
use)
Controls strobe duration operation. Refer to
"Strobe Duration DMX Timing
Detail" on page 30
.
Controls strobe rate operation. Refer to
"Strobe Rate DMX Timing Detail" on
page 29
.
Zone 3
Zone 6
Sh wline