Chapter 3: Connecting Cables To The Mx7 Tecton; Connecting The Usb Client And Power Cable - Honeywell MX7 Tecton User Manual

Chapter 3: Connecting Cables to the MX7 Tecton

Connecting the USB Client and Power Cable

Note: AC/DC Adapter must be assembled before this process begins.
Note: Do not connect AC power to the AC Adapter yet.
1. Holding the cable I/O connector, pinch the catch release buttons in until the catches are open. Connect the cable to the
MX7 Tecton I/O port by matching the shape of the I/O connector on the cable with the shape of the I/O connector at the
base of the MX7 Tecton. Release the catch release buttons.
2. Insert the AC adapter single pin cable .
3. Connect the AC Adapter to a power source (wall outlet).
4. Insert the USB client plug into the target USB Client port.
The MX7 Tecton and the USB client are connected.
3-1