Touch Screen; Calibrating The Touch Screen; Adjusting The Display Backlight Timer; Apply The Touch Screen Protective Film - Honeywell MX7 Tecton User Manual

Touch Screen

Calibrating the Touch Screen

If the touch screen is not responding properly to stylus taps, you may need to recalibrate the touch screen.
Recalibration involves tapping the center of a target. If you miss the center, keep the stylus on the screen, slide it over the
target's center, and then lift the stylus.
To recalibrate the screen, select Start > Settings > Control Panel > Stylus > Calibration tab.
Follow the instructions on the screen and press the Enter key to save the new calibration settings or press Esc to cancel or
quit.

Adjusting the Display Backlight Timer

Start > Settings > Control Panel > Display > Backlight
The backlight settings use the Honeywell set of default timeouts and are synchronized to the User Idle setting in the Schemes
tab in the Power control panel.
When the backlight timer expires, the display backlight is dimmed, not turned off. When both checkboxes are unchecked, the
backlight never turns off (or dims).
Default values are 3 seconds for Battery, 2 minutes for External and both the check boxes are enabled.
This backlight setting as well as the user idle power scheme controls both the keypad and display backlights.
Different timeouts can be set for the backlights when on battery or external power. The backlights timer can be disabled for a
particular mode by unchecking the checkbox. When the backlight timer is disabled, the backlight never turns off (or dims) in
that mode.

Apply the Touch Screen Protective Film

First, clean the touch screen of fingerprints, lint particles, dust and smudges.
Remove the protective film from its container. Remove any protective backing from the film sheet by lifting the backing from a
corner of the film. Discard the backing.
Apply the film to the touch screen starting at one side and smoothing it across the display. If air bubbles appear, raise the film
slightly and continue smoothing the film across the display until it covers the glass surface of the display. If dust, lint or
smudges are trapped between the protective film and the glass display, remove the protective film, clean the display and apply
the protective film again.
Contact Technical Assistance about protective film packs designed specifically for your MX7 Tecton touch screen.
2-8