Table of Contents
Advertisement
Chapter 5
General Setup Parameters
Spotter Beam
5–6
You can enable the scanner to use a spotter beam
which helps when aiming the scanner. Each time you
press the trigger, the scanner generates a bright laser
spot for a fixed duration, after which the scanner
beam is activated.
The spotter beam is recommended for long range
applications.
Scanning label NP disables the spotter beam. Hold
the trigger for two seconds after scanning.
NP
To enable the spotter beam, scan label NQ, then scan a
digit from 0 – 9 (Appendix B), holding the trigger
for two seconds after scanning the digit. Each
digit enables the spotter beam for a specified duration
as shown in the table below. For example, to enable
the spotter beam for 200 milliseconds, scan the NQ
label, then scan code 3 in Appendix B.
NQ
This Digit
Enables Spotter Beam for:
50 ms
0
100 ms
1
150 ms
2
200 ms
3
250 ms
4
300 ms
5
350 ms
6
400 ms
7
450 ms
8
500 ms
9
Note: Spotter Beam and Autosense Mode are
mutually exclusive parameters. Only one of these
parameters can be enabled at a time.
Disable
Spotter Beam *
+
Enable Spotter Beam=xx msec
Advertisement
Table of Contents
