Table of Contents
Advertisement
Chapter
Objectives
System
Status
General Setup Parameters
This chapter describes parameters specific to the
operation of the scanner including:
System Status
Power Consumption
Beeper Operation
Capture Count
Spotter Beam
Autosense Mode
To set specific operating parameters, scan the
appropriate bar code labels in each section.
Note: Throughout this chapter, default settings for
parameters are flagged by an asterisk (* ).
The labels in this section allow you to examine the
configuration of your system.
To send a list of currently programmed parameters to
the display device, scan option ZB. A sample display
is shown on the top of the next page.
Note: Scanning ZB may interfere with your terminal
software, depending on your application.
ZB
5
Chapter
Display Configuration
A–B
5–1
Advertisement
Table of Contents
