Table of Contents
Advertisement
Chapter 4
Setup Instructions
Enabling
Wedge Mode
Selecting a
Terminal Type
1
Can be used in AT or XT mode depending on the internal jumper. See DL40 User Manual.
2
Can be used in AT or XT mode depending on the DIP switch setting. See User Manual for 1784-T35.
4–6
After installing the keyboard wedge interface you
need to enable the scanner to operate in wedge mode.
If this is a first time installation you must enable
the scanner to operate in wedge mode.
To enable wedge mode, scan label CE and listen for
two short beeps.
CE
You now need to identify the type of terminal that the
wedge interface is connected to. Scan the appropriate
label below and listen for two short beeps.
First time installations require you to program the
scanner for use with the connected terminal.
CF
CG
Enable
Wedge Mode *
PC-AT *
PS/2 and 50/60/80
Allen-Bradley 6121
Allen-Bradley 1784-T50, -T60
Allen-Bradley 2706-DL40
Allen-Bradley 1784-T35 (AT mode)
Compaq 386, 286
PC-XT
Allen-Bradley 6120, 2706-DL40
Allen-Bradley 1784-T35 (XT mode)
Compaq Deskpro
1
2
1
2
Advertisement
Table of Contents
