Genie H User Manual page 9

CAUTION
Make sure that the carriage magnet is in place in the
top of the carriage slide.
5. Slip carriage into carriage slot of rail.
• Flip the rail assembly up side down.
• Place emergency release lever in "release"
position (See below).
– Check arrow on the side of carriage points
toward door end of rail.
– Slide carriage into rail at power head end
(Fig. 1-5).
– Flip rail assembly right-side up.
6. Attach rail to power head.
• Place rail in front of power head with rail strap at
opposite end.
• Support door end of rail (rail strap) at about same
height as power head.
– Check if magnet is in place (Fig. 1-6 inset). Insert
carriage slide into rail (Fig. 1-6). (Carriage slide is
long straight piece attached to chain.)
– Pull rail toward you as you feed chain into it.
(Fig. 1-6). When the end of the rail is within
about 2 chain links of the power head, you can
then push it the rest of the way. (It is a snug fit.)
– Securely fasten with 2 bolts (9) and nuts (10)
(Fig. 1-7).
[ 9 ] 1/4"-20 x 5/8"
OPEN GREEN PARTS BAG
7. Attach emergency release cord, knob and tag.
• Tie overhand knot in 1 end of cord. Tighten knot.
(FIG. 1-8 inset A).
– Slip opposite (no knot) end through knob.
– Slip through hole in emergency release lever
(Fig. 1-8).
– Tie overhand knot in this end also. Tighten knot.
8. Attach emergency release tag.
• Attach to hole in emergency release using metal
twist tie on tag. (Fig. 1-8 inset B).
Lever in release position.
Rail is up-side down
FIG. 1-5 Align arrow.
carriage slide
magnet
[ 10 ]
FIG. 1-6 Slip carriage slide into rail.
1/4"-20
FIG. 1-7 Attach rail to power head.
B
wire
twist
tie
FIG. 1-8 Attach emergency release cord & tag.
overhand knot
A
9