Entering A Default Setting For The Amount Of Water For A Cup Size; Cappuccino With The Professional Cappuccino Frother - Jura ENA 3 Instructions For Use Manual

E The pre-set amount of water can be
changed during the brewing operation by
turning the Rotary Switch.
One-off settings before and during coffee
preparation always follow this model. These
settings are not saved.
Example: Changing the coffee strength of
1 coffee before preparation from
to .
STRONG
Precondition:
READY
Place the cup under the coffee spout.
T
Turn the Rotary Switch until
g T
displayed.
Press the Rotary Switch until
k T
displayed.
During grinding the coffee strength
is displayed.
STRONG
, the pre-set amount of water flows
1 CUP
into the cup, preparation stops automati-
cally.
READY
Entering a default setting for the amount of
water for a cup size
A default setting can be entered for the
E
amount of water for 1 coffee. When
preparing 2 coffees this amount is
dispensed per cup.
Precondition:
READY
Place the cup under the coffee spout.
T
Press the Rotary Switch and hold it down.
k T
During grinding the strength of the coffee
is displayed.
Continue to hold the Rotary Switch down
k T
until
ENOUGH COFFEE ?
The coffee flows into the cup.
NORMAL
is shown on the display.
is
STRONG
is
STRONG
is shown on the display.
appears.
Press the Rotary Switch again when enough
k T
coffee has been filled into the cup.
, the default setting for the amount of
OK
water for one coffee has been entered.
READY
E This setting can be changed at any time by
repeating the above procedure.
Cappuccino with the
Professional Cappuccino Frother
Precondition:
READY
Remove the protective cover from the
T
Professional Cappuccino Frother.
Connect the milk pipe to the nozzle.
T
Insert the other end of the milk pipe into a
T
milk carton or connect it to a milk
container.
Place a cup under the nozzle.
T
Set the selector lever of the nozzle to the
T
milk foam position.
p
Turn the Rotary Switch until
g T
displayed.
Press the Rotary Switch.
k T
HEATING
appears as soon as the ENA is
READY
sufficiently heated.
Turn the switch to position
l T
, the milk foam is being prepared.
STEAM
Turn the switch clockwise to position
y T
when there is sufficient milk foam in the
cup.
E You can prepare more milk foam within
about 40 seconds.
ENA 3
is shown on the display.
is
STEAM
.
m
o
17
en
en
en
en
it