Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Jura IMPRESSA E85
Summary of Contents for Jura IMPRESSA E85
- Page 1 IMPRESSA E80/85 Instructions for use 7/05...
-
Page 2: Jura Impressa E80/85
JURA IMPRESSA E80/85 Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. JURA Elektroapparate AG, CH-4626 Niederbuchsiten, = Note = Important = Tip Internet http://www.jura.com... - Page 3 Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig. 14 Fig. 15 Fig. 16 Fig.17 Fig. 18...
- Page 4 Control elements 1. Rotary Switch 2. Illuminated ring 3. Programming key 4. Draw-off key 2 cups 5. Powder coffee selection key 6. Draw-off key 1cup 7. Steam pre-selection key 8. ON/OFF key 9. Maintenance key 10. Display dialog system 11. Water tank with carrying handle 12.
-
Page 5: Table Of Contents
Contents 14. Switching off the IMPRESSA E80/85 ....page 14 JURA IMPRESSA E80/85 15. Programming ..........page 14 1. Safety information..........page 6 15.1 Programming the filter ......page 15 Warning ..........page 6 15.2 Programming the water hardness ....page 15 Precautions ..........page 6 15.3 Programming the aroma STANDARD 2. -
Page 6: Safety Information
You will also find useful tips on operation and maintenance When disconnecting the mains cable never pull on the mains of your IMPRESSA E80/85 on the website at www.jura.com. cable or the machine itself. Don’t forget to check out the Knowledge Builder our ani- The coffee machine is connected to mains supply via a mains mated operating instructions. -
Page 7: Fill Water Tank
(e.g.during holidays) time and to avoid damage, please note that the grinding gear of your JURA coffee machine is not suitable for coffee beans 3. First use which were treated, during or after roasting, with additives (e.g. -
Page 8: Adjusting The Water Hardness
Fill the water tank (11) with fresh water. If the filter is activated, the program step Water Hardness no longer appears. OPEN TAP Place an empty cup under the replaceable hot water nozzle (17). The IMPRESSA E80/85 has 5 hardness degrees which can Open the steam / hot water draw-off tap (15) (Fig. -
Page 9: Installation Of Claris Plus Filter Cartridges
Press the Rotary Switch (1) to confirm the required level. Put a sufficiently large container (approx. 1 litre) under the replaceable hot water nozzle (17). HARDNESS If not installed already, insert the CLARIS plus filter. Press the programming key (3) to quit the programming mode. -
Page 10: Replacing The Filter Without Display Request
RINSING Press the maintenance key (9). FILTER RINSE SHUT TAP READY Close the steam / hot water draw-off tap (15). HEATING 6.1 IMPRESSA E80/85 rinsing without display request READY Press the maintenance key (9) until RINSE is displayed 5.3 Replacing the filter without display request Press the Rotary Switch (1) Rinsing, cleaning, de-scaling and filter replacement can also be RINSE... -
Page 11: Drawing Off 1 Cup Of Coffee
Your product is being prepared. 8. Drawing off 1 cup of coffee READY You can increase the strength of your coffee at any time during the grinding operation by pressing the 1 cup draw- off key again. 9. Drawing off 2 cups of coffee For Example: Press the 1 cup draw-off key three times to Selecting the coffee strength is not possible when drawing... -
Page 12: Drawing Off Pre-Ground Coffee
10. Drawing off pre-ground coffee POWDER Your product is being prepared. Never use instant coffee or quick-coffee. We recommend that you always use powder from fresh coffee beans or, pre- READY ground, vacuum-packed coffee. Never fill in more than 2 portions of powder. -
Page 13: Drawing Off Steam
Before CLOSE TAP water may still escape the system. Press the steam pre-selection key (7). HEATING STEAM 12. Drawing off steam To draw off steam, open the steam/hot water draw-off tap (15) To ensure perfect operation, clean the 2-stage frothing jet (Fig. -
Page 14: Connecting The Professional Cappuccino Frother To Your Impressa E80/85
The optionally available milk container can be used for sucking in milk. How to connect it (see Fig. 8). For proper cleaning, use the JURA Auto Cappuccino Clean- ing Agent This is available at your authorized dealer. The 13.2 Drawing off cappuccino and hot milk using instructions for use you’ll find on the agent. -
Page 15: Programming The Filter
¼ Stats Turn the Rotary Switch (1) until the following message is dis- ¼ Language played: ¼ ML / OZ STANDARD ¼ Rinse To confirm the new aroma settings, press the Rotary Switch (1). AROMA Programming key Use the programming key (3) to open or quit the pro- Press the programming key (3) to quit the programming... -
Page 16: Cup Counter
15.6 Programming the language Press the programming key (3) to quit the programming mode or select the next programming item using the Rotary READY Switch (1). Press programming key (3) until READY FILTER is displayed. The illuminated ring (2) is active. 15.5 Cup counter Turn the Rotary Switch (1) until LANGUAGE is displayed. -
Page 17: Switch-Off Rinsing Operation
16.2 Emptying the coffee grounds container Turn the Rotary Switch (1) until the message OZ is displayed. EMPTY GROUNDS To confirm the new setting, press the Rotary Switch (1) If this message appears on the display, you can no longer Press the programming key (3) to quit the programming draw off coffee. -
Page 18: Replacing The Filter
(chapter 17) within the next few days. Disassemble the 2-stage frothing jet for proper cleaning (Fig. 18). JURA cleaning tablets which are specially designed for the The water tank should be rinsed daily and refilled with fresh cleaning program of your IMPRESSA E80/85 are available water. -
Page 19: Cleaning The Impressa E80/85 Without
However, we recommend that you should de-scale the machine (Chapter 18) within the next few days. TABLET JURA de-scaling tablets which are specially designed for the Fill in the tablet (see Fig. 15) de-scaling program of your IMPRESSA E80/85 are available PRESS at your authorized dealer. -
Page 20: De-Scaling The Impressa E80/85 Without Display Request
EMPTY OPEN TAP DRAWER Open the steam / hot water draw-off valve (15) (Fig. 13) Empty the drawer DECAL ON DRAWER SHUT TAP MISSING After you have closed the steam / hot water draw off tap (15), Insert the drawer again. the following message is displayed SOLVENT DECAL ON... -
Page 21: Disposal
19. Disposal Please return the IMPRESSA E80/85 machine to your local dealer, the service shop or to JURA for proper disposal. 20. Tips for perfect coffee Height-adjustable coffee spout (18) You can adjust the height of the coffee spout to the size of your cups (Fig. -
Page 22: Messages
Filter used up Replace filter (chapter 5.2) MACHINE READY ERROR General fault - switch off - disconnect from mains supply - Connect IMPRESSA E80/85 to power supply - Switch on IMPRESSA E80/85 - Have IMPRESSA E80/85 checked by JURA Service... -
Page 23: Problems
Pre-ground coffee too fine Use a coarser pre-ground coffee High-frequency, electromagnetic interference may influence the display. Drawing off coffee is possible at any time. If the messages or problems still persist, please contact your local authorized dealer or JURA Elektroapparate AG. -
Page 24: Legal Information
Any Pump pressure: static max. 15 bar obligations to be fulfilled by JURA Elektroapparate AG are stipu- Water tank: 1,9 Liter lated in the corresponding purchase contract, which also contains the full and solely applicable warranty stipulations.
Need help?
Do you have a question about the IMPRESSA E85 and is the answer not in the manual?
Questions and answers
I recently bought the Jura Impressa E85 machine used and **** trying to clean it out properly. How can I open my newly purchased milk cleaner? I've tried to google search it, but can't find out how to get this thing to open up, despite trying to use the vertical lines on either side, using pliers or teeth.
To open the milk cleaner on the Jura Impressa E85, follow these steps:
1. Press the "Pc" button.
2. Press the "Milk System Cleaning" button.
3. Press the "Start" button.
4. Press the "Next" button.
5. Remove the milk hose from the milk container or milk carton.
6. Fill the designated milk system cleaning container with Jura Milk System Cleaner up to the lower marking.
7. Add water up to the upper marking.
8. Place the container under the fine foam frother.
9. If using the professional fine foam frother, set the selector lever to the milk foam position.
10. Connect the milk hose to the container.
This process ensures proper cleaning of the milk system.
This answer is automatically generated