Removing The Torque Limiter - Konica Minolta PagePro 1380 MF Service Manual

(5)

Removing the Torque Limiter

1. Remove the Paper take up Clutch Gear.
☞ D-25
Torque Limiter
Precautions for Installation of the Torque Limiter
The Coupling Gear has five notches for adjustment of the Take-up Roller position. When
the Torque Limiter is replaced, adjust the set position of the Coupling Gear so that the Take-
up Roller becomes level. The procedure is as follow.
Look at the stop position of the Take-Up Roller from the Clutch Gear side.
20. Unhook two tabs and remove the Paper Take-Up
Clutch Gear.
4136D057AA
2. Unhook three tabs and take apart the Paper
Take-Up Clutch Gear then, remove the Torque
Coupling
Limiter.
Gear
4136D043AA
After replacing the Paper Take-Up Clutch Gear
(Torque Limiter) on the shaft, rotate the Paper Take-
Up Clutch Gear by hand (the Solenoid Flapper needs
to be released).
4136D060AA
D-27
4136D044AA