Konica Minolta PagePro 1380 MF Service Manual page 152

Code Status
DCN
xxxx62
received
Too many
xxxx63
CRP
Too many
xxxx64
PPR
RNR time
xxxx65
Out
RTN/PIN
xxxx66
Received
Comm. Error (at Phase-E)
xxxx70 Time Out
Description
• Received Disconnect
command (DCN) from
other side at Phase D.
• Received Command
Repeat (CRP) from other
side more than 3 times
after sending (PPS-) Q
Command.
• Received Failure to Train
(FTT) from other side
even with the minimum
speed of 2400 bps.
• Other side was not in RX
mode within 60 seconds
in Flow Control.
• Received Negative
response from other side
for Q Command.
• Did not receive DCN
within 6 seconds at Phase
E.
T-42
Cause
• Failure in • Check the status
machine of TX of the machine
side of TX side
• Line failure • Retry TX
• Line failure • Retry TX
• Failure in • Check the status
remote machine of the remote
machine
• Line failure • Retry TX
• Failure in • Check the status
remote machine of the remote
• Line failure machine
• Retry TX
Action