I Setting Tag Channels; I Starting A Scan - Icom IC-M421 Instruction Manual

I Setting tag channels

For more efficient scanning, add the desired channels as tag
channels or clear the tag for unwanted channels.
Channels are not tagged will be skipped during scanning. Tag
channels can be assigned to each channel group (Interna-
tional and U.S.A.*) independently.
q Push both [L] and [M] to select the desired channel group
(International and U.S.A.*).
w Select the desired channel to be set as a tag channel.
e Push [SCAN•TAG] for 1 sec. to set the displayed channel
as a tag channel.
• " " appears in the display.
r To cancel the tag channel setting, repeat step e.
• " " disappears.
✔ Clearing (or setting) all tagged channels
While pushing [HI/LO] on the microphone, push [SCAN•TAG]
for 3 sec. (until a long beep changes to 2 short beeps) to clear
all tag channels in the channel group.
• Repeat above procedure to set all tag channels.
[Example]: Starting a normal scan.

I Starting a scan

Set scan type (priority or normal scan) and scan resume timer
in advance using set mode. (p. 45)
q Push [L] and [M] to select the desired channel group (In-
w Set tag channels as described at left.
e Make sure the squelch is closed to start a scan.
r Push [SCAN•TAG] to start priority or normal scan.
t To stop the scan, push [SCAN•TAG].
*U.K. version only
Scan starts.
Push
SCAN OPERATION
ternational and U.S.A.*) if desired.
• " " or "
display.
• When a signal is detected, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to set mode
setting. (Channel 16 is still monitored during priority scan.)
• Push [L] or [M] to check the scanning tag channels, to change
the scanning direction or resume the scan manually.
• A beep tone sounds and " " blinks when a signal is received
on Channel 16 during priority scan.
When a signal is received.
5
5
" appears in the function
13