HUSKY LINERS 47954 Installation Instructions

HUSKY STORAGE BOX INSTALLATION INSTRUCTIONS
Please check contents and read instructions before beginning (some contents inside drawer of box)
You have received hardware for both Excursion and Suburban installation (not all hardware will be used)
1- Drawer Unit
1- Cam Spacer
1- 3/8"-24 Lock Nut
3- #8 X 1_" Stainless Steel Wood Screw
2- 4" Long Straps
1- 45_" Channel Iron (with 2 holes)
1- Cam latch
2- 3 1/2" Long Clamp Plates
2- M10 X 60 Allen Bolts
8-3/8" Flat Washers
1/8" Allen Wrench
3/8" Combination End Wrench
9/16" Socket and Ratchet
1) Before beginning installation, check factory positioning of jack and jack tools. If Storage Box will
block access to these items when installed, remove them before installing Storage Box. These items may
be stored in your Storage Box once installation is completed.
2) Remove Storage Box from packaging. Check to insure you have received all the above listed
Contents and that no damage has occurred during shipping.
3) Position Storage Box top side down, placing it on a flat, non-marring surface. Remove shipping blocks
and Channel Iron from bottom of drawer using Phillips Head Screwdriver. Removing block will allow
drawer to slide out so use caution and avoid tilting Drawer Unit.
4) Turn Storage Box back over (right side up and laying flat on a non-marring surface) and extend the
drawer to the full open position.
5) Remove Detent Pin from each drawer slide by applying downward pressure on Detent Pin (see note #1).
Detent Pins will be re-inserted later so do not dispose of them.
6) Remove drawer from the Storage Box and stand it vertically on its back wall (once again on a non-
marring surface). Using a 1/8" Allen Wrench and 3/8" End Wrench, remove the two 10-32 flathead bolts
and nuts from handle installation area. Note that there are spacers (thick washers) located between the front
and rear extrusions that make up the drawer face. Should the spacers move out of position when the bolts are
removed, reposition them before completing handle installation. Repositioning a spacer that has fallen out is
easily done by resting the spacer on your finger and raising the spacer up into the handle opening from the
inside of the drawer. To avoid the spacer falling out do not tip drawer when handle bolts are removed.
7) Remove the 3/8"-24 lock nut, cam latch and spacer from Handle Assembly. Align handle with holes
(shank will pass through opening in drawer) and re-install the 10-32 flathead bolts/nuts using 1/8" Allen
Wrench. On the inside of the drawer, re-install the spacer, cam latch and 3/8"-24 lock nut on handle shank,
tighten nut only finger tight. Turn handle and note the position of the cam latch. The cam latch should be

PACKAGE CONTENTS

TOOLS REQUIRED

INSTALLATION

1- Handle Assembly
2- 3/8"X 2-3/4" Hex Bolts
4- 3/8"X 1-1/2" Hex Bolts
1- Cargo Liner Retention Block
1- Cargo Liner
1- Drawer Liner (Foam)
2- 1" Round Spacers
2- 5" Long Nut Plates
8mm Allen Wrench
T-50 Torx Wrench
Phillips Head Screwdriver
Package
47954_Instruction Sheet.doc
09/11/2006