Tabletop Installation - VTech CD1261 User Manual

Getting started

Tabletop installation

To return the bracket from wall installation to tabletop position, remove the
telephone from the wall mount bracket and unplug the telephone line cord from
the wall jack, then follow the instructions below.
1. Lift the handset and place it
aside. On the telephone base,
press and slide the handset
cradle tab upwards until it is out
of the slot. Rotate the tab so that
the end with the hook is down.
Then insert the tab back into its
slot until it clicks into place.
3. Rotate the bracket 180
degrees to the tabletop
position. Insert the tabs on
the bracket into slots c and
d on the base, then push
the bracket downwards until it
clicks into place.
2.
4.
RELEASE TO
PUSH
c
d
PUSH
TO RELEASE
Hold the telephone base with both
hands with the bottom of the telephone
base facing towards you, then slide the
bracket downwards until it detaches
from the telephone base.
Route the telephone line cord through
the channel as show below. Plug the
other end of the telephone line cord into
a telephone wall jack. Put the telephone
on the table and then place the handset
back on the telephone base.
9
RELEASE TO
PUSH
PUSH
TO RELEASE