Table of Contents
Advertisement
DV3251-En-QuickStartGuide.fm Page 4 Tuesday, December 13, 2005 2:03 PM
4. Connect the antenna cable
Connect a TV antenna cable fly-lead from your TV antenna system or Cable TV (CATV) to the
antenna input on the rear of the display.
Check to make sure that all cable connections are correct and firmly in place. For best
reception, you should have a properly aligned outdoor antenna system.
5. Connect the power cable
1. Locate the power cable from the packaging, unwrap it, and plug the appropriate end into
the AC input socket on the rear of the display (as illustrated below).
2. Connect the other end into an appropriate wall power outlet, and switch it on (if switched).
The display will enter standby mode and the power indicator (on the front lower right) will
light up red.
• The type of power cable plug and socket illustrated may differ from the type used in your
region.
• Only use an appropriate power cable for your region. Never use a power cable which appears
damaged or frayed. Never change the plug type on a power cable. Be aware of total loading
when using extension cords or multiple outlet power boards.
WARNING: This BenQ LCD display has been engineered and manufactured with the highest
priority on safety, however IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK
OR FIRE HAZARD.
4
Section 1: Quick Start Guide
Antenna cable
To antenna input terminal
Power outlet
Power Cable
Advertisement
Table of Contents
