Technical Data; Installation - Electrolux EX601SC User Manual

16 electrolux
There are streaks, milky
spots or a bluish coating on
glasses and dishes
Dry water drop stains on
glasses and dishes

TECHNICAL DATA

Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

INSTALLATION

There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Inlet water supply
• Cold water pressure: 800 kPa max -
50 kPa min
• Water flow rate 10 L/minute min.
• If cold water pressure is in excess of
800 kPa, a pressure-reducing valve
should be used. Check for leaks.
The cleaning results are not satisfactory
• Decrease the rinse aid dosage.
• Increase rinse aid dosage.
• The detergent can be the cause.
Width (mm)
Height (mm)
Depth (mm)
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher door.
Minimum
Maximum
Place settings
The hose s hould not be
extended by more than
2 metres or water pump-
out problems ma y occu r
Secure dishwasher with
brackets and screws provided
Gap on both sides should be
equal, & no greater than
5mm per side.
• K ickplate fixing screws
If floor is not level, adjust
levellin g legs to suit
Remove entire plastic
Fix drain hose max of
membrane from sink trap
10mm below the top of
spigot & fit drain hose to spigot
the dishwashe r
with clamp
600mm max.
300mm min.
•
POWE R S UPPL Y
230/240V - 1 0 Amps
596
818 - 878
575
50 kPa (7 psi)
800 kPa (116 psi)
12