Water Connection - Electrolux EX601SC User Manual

18 electrolux
2. Use the supplied screws to secure the
appliance in position (upwards or side-
ways). Make sure the screws are tight-
ened.
Custom made kick-panel
For integrated appliances and full-stainless-
steel door appliances.
We recommend that you make a custom
made kick-panel that aligns your kitchen
cabinets.

WATER CONNECTION

Water inlet hose
Connect the appliance to a cold water sup-
ply.
Connect the inlet hose to a water tap with
an external BSP thread spout of 3/4".
Inlet water supply
• Cold water pressure: 800 kPa max - 50
kPa min.
• Water flow rate 10 L / minute min.
• A notched continuous panel is necessary
to prevent door swing interference and to
keep kick-panel alignment with adjacent
units.
• Cut a notch in the kick-panel sufficient to
let the door swing freely under the appli-
ance.
• Make a check for interference. Open and
close the door slowly. If the door touches
the kick-panel, trim to prevent interfer-
ence.
• Attach the kick-panel to adjacent cabi-
nets so that if service is necessary you
can remove it.
• If cold water pressure is in excess of 800
kPa, a pressure reducing valve should be
used. Check for leaks.
Caution! Always use new hoses when
you connect the appliance to the water
mains. Old hoses must not be used.
The water inlet hose must be examined
at an interval of twelve months for
deterioration and replaced if necessary.