Electrolux EX601SC User Manual page 15

Warning! Switch the appliance off
before you do the suggested corrective
actions.
Fault code and malfunction
• intermittent audible signal,
• the digital display shows
The appliance does not fill with wa-
ter
• intermittent audible signal,
• the digital display shows
The appliance will not drain
• intermittent audible signal,
• the digital display shows
The anti-flood device operates
The program does not start
After the check, switch on the appliance.
The program continues from the point of in-
terruption. If the malfunction shows again,
contact your Customer Care Centre.
If the display shows a fault code, not de-
scribed in the chart, contact your Customer
Care Centre.
These data are necessary to help you
quickly and correctly:
The dishes are not clean
Limescales particles on the
dishes
The dishes are wet and dull
• The water tap is blocked or restricted with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The installation of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The installation of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
• Close the water tap and contact your Customer Care Cen-
tre.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected.
Plug-in appliance to the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the program immediately.
The cleaning results are not satisfactory
• The selected washing program is not applicable for the type of
load and soil.
• The baskets are loaded incorrectly so that water cannot reach all
surfaces.
• Spray arms do not turn freely because of incorrect arrangement of
the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
• The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
• No rinse aid has been used.
• The rinse aid dispenser is empty.
Possible cause and solution
• Model (Mod.)
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
electrolux 15