Technical Data - Electrolux GA60SLV220 User Manual

72 electrolux
Problem
Limescale particles on the
dishes.
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and matt.
Activating the rinse aid dispenser
1. Open the menu option.
2. Go to SETTINGS .
3. Press the OK /Start button to open the
submenu.

TECHNICAL DATA

Dimensions
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of
the appliance door shows the electrical
connection data.
Possible cause
The spray arms could not turn
freely. Incorrect position of the
items in the baskets.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect level of the water soft-
ener adjustment.
The salt container cap is not
closed correctly.
The rinse aid quantity is too
high.
The rinse aid quantity is too
low.
The detergent can be the
cause.
The washing programme was
without a drying phase or with
a decreased drying phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on (this
function automatically deacti-
vates the rinse aid dispenser).
4. Go to RINSE AID and activate the rinse
5. Press the OK /Start button.
6. Press the Option button to close the
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
Possible solution
Make sure that an incorrect po-
sition of the items do not cause
the blockage of the spray arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener with
the correct level.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid quantity.
Increase the rinse aid quantity.
Use a different brand of deter-
gent.
For better drying results, keep
the door ajar for some minutes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispenser.
aid dispenser.
menu option.
If the hot water comes from alternative
sources of energy, (e.g. solar panels,
photovoltaic panels and aeolian), use a
596 mm
818 - 898 mm
550 mm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
12