Technical Data - Electrolux ESF 640 Installation And User Instructions Manual

Technical data
Voltage: 240 V, single-phase +earth
Fuse rating: 13 A
Type of current: CA, 50 Hz
Power: > Element power 2100 W
Total 2300 W
Water: pressure: . 80-1000 kPa (0.8-10 kp/cm2)
Mains connection: 1.5 m lead with plug.
Connection: Cold-fill (approx. 15°C).
Water hardness: Above 10° dH
Capacity: 12 IEC international standard place settings.
CONNECTING TO THE MAINS
Before you use your dishwasher, check that the voltage shown on the data plate conforms with your mains supply.
The mains lead of the dishwasher is fitted with a non-rewireable moulded on 13 amp plug containing a 13 amp
fuse. In the event of the fuse requiring replacement the fuse cover/carrier should be removed using a small screw- .
driver to lever it out. The old fuse should be replaced by a 13 amp approved BS1362 fuse and the fuse cover/carrier
must be refitted before the plug is used again. If the fuse cover/carrier is lost, a replacement can be obtained from
an electrical shop. The fuse cover/carrier must be of the same colour as that of the colour insert in the base of the
plug. In no circumstances must the plug be used without a correct fuse cover/carrier fitted.
If the plug supplied on the mains lead is not suitable for the socket outlet in your home it should be cut off and dis-
posed of safely or destroyed to avoid any possible shock hazard resulting from the plug being inserted into a 13
amp socket elsewhere in the house. A suitable replacement plug should be fitted (as in fig 1). Ifa 13 amp plug and
socket are not used the ciruit supplying the dishwasher should contain a 15 amp fuse.
WARNING! THIS APPLIANCE MUST BE EARTHED AND PROTECTED BY A 13 AMP FUSE.
IMPORTANT! THE WIRES IN THE MAINS LEAD OF THIS APPLIANCE ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
GREEN- and-YELLOW : Earth tig. 1
BLUE: Neutral
BROWN: Live
As the colours of the wires in the mains lead may not correspond with the
coloured markings identifying the terminals in your plug proceed as fol-
lows.
'Connect the GREEN-and-YELLOW coloured wire to the plug terminal
marked letter "E" or earth oar or coloured GREEN or GREEN-and-
Yellow.
GREEN-and-YELLOW
` Connect the BROWN coloured wire to the plug terminal marked let-
ter"L" or coloured RED.
Connect the BLUE coloured wire to the plug terminal marked letter "N"
CORD CLAMP
or coloured BLACK. i po
Care should be taken to ensure the machine does not stand on the electrical supply cable.
eRe: