fee, to go back to making coffee using beans,
deactivate the pre-ground coffee function by
pressing the
icon (B4) (fig. 8).
NOTE 1: Never introduce pre-ground coffee when
the machine is off or it could spread through the
inside of the appliance.
NOTE 2: Never add more than 1 measure, other-
wise the appliance will not make the coffee.
NOTE 3: Use the measure provided only.
NOTE 4: Introduce only pre-ground coffee for
espresso coffee machines into the funnel.
NOTE 5: If more than one measure of pre-ground
coffee is used and the funnel clogs, push the cof-
fee down with a knife (fig. 21) then remove and
clean the brewing unit and machine as described
in the "Cleaning the brewing unit" section.
DELIVERING HOT WATER
•
Always make sure the appliance is ready.
•
Make sure the water spout is in place and at-
tached to the nozzle (fig. 6).
•
Position a container under the spout.
•
Press the
icon (B13) (fig. 20).
The appliance displays: "HOT WATER PRESS
OK".
Press the OK icon (B9) again and hot water is
delivered from the water spout into the con-
tainer underneath.
You should not deliver hot water for more
than 2 minutes at a time.
To interrupt, press the
ESC icon (B6).
The appliance stops delivery once the set
quantity is reached.
CHANGING THE QUANTITY
OF HOT WATER
The machine is set by default to automatically de-
livery 150 ml of hot water.
To change these quantities, proceed as follows:
•
Place a container underneath the water spout
(fig. 5).
•
Press the
icon (B2) to enter the menu
(fig. 15) or press the
icon (B13) or the
icons (B7) and
16
(B8) (fig. 2) until "PROGRAM HOT WATER"
is displayed.
•
Press the OK icon (B9) to confirm.
•
Select the required quantity of water by pres-
sing the
icons (B7) and (B8).
The progress bar shows the quantity of water
selected.
•
Press the OK icon (B9) to confirm (or the
ESC icon (B6) to cancel the operation.
•
Press the ESC icon (B6) (fig. 18) twice to exit
the menu.
•
The appliance is now reprogrammed with the
new settings and is ready.
MAKING CAPPUCCINO
N.B.: Set the quantity of coffee you want
to use to make the cappuccino in the "Program
cappuccino" function in the menu.
•
Select the taste of the coffee you want to use
to make the cappuccino by pressing the
icon (B4).
•
Remove the lid of the milk container.
•
Fill the container with about 100 grams of
milk for each cappuccino to be prepared (fig.
23). Never exceed the MAX level (correspon-
ding to about 750 ml) marked on the contai-
ner.
You should ideally use skimmed or semi-
skimmed milk at refrigerator temperature
(about 5°C).
•
Make sure the intake tube is correctly inser-
ted in the rubber washer (fig. 24) then re-
place the milk container lid.
•
Position the frothed milk regulator (C1) bet-
ween the words CAPPUCCINO and CAFFE-
LATTE printed on the milk container lid.
The quantity of froth can be adjusted by mo-
ving the regulator towards the word CAFFE-
LATTE for a denser froth. Moving it towards
the word CAPPUCCINO obtains a less dense
froth.
GB