Delivering Hot Water; Changing The Quantity Of Hot Water; Making Cappuccino (Using The Steam Function) - Electrolux EBA63810X Instructions Manual

NOTE 4: Introduce only
pre-ground coffee for
espresso coffee machines
into the funnel.
NOTE 5: If more than one
measure of pre-ground
coffee is used and the fun-
nel clogs, push the coffee
down with a knife (fig. 21)
then remove and clean the
brewing unit and machine
as described in the "Clea-
ning the brewing unit" section.

DELIVERING HOT WATER

• Always make sure the appliance is ready.
• Turn the cappuccino maker outwards and
place a container underneath (fig. 5).
• Press the icon (B13) (fig. 20).
The appliance displays: "HOT WATER PRESS
OK".
Press the OK icon (B9) again and hot water is
delivered from the cappuccino maker into the
container underneath.
You should not deliver hot water for more
than 2 minutes at a time.
To interrupt, press the
ESC icon (B6).
The appliance stops delivery once the set
quantity is reached.
CHANGING THE QUANTITY
OF HOT WATER
The machine is set by default to automatically de-
livery 200 ml of hot water.
To change these quantities, proceed as follows:
• Place a container underneath the cappuccino
maker (fig. 3).
• Press the icon (B2) to enter the menu
(fig. 15) or press the
(B8) (fig. 2) until "PROGRAM HOT WATER"
is displayed.
• Press the OK icon (B9) to confirm.
• Select the required quantity of water by pres-
•
•
•
MAKING CAPPUCCINO
(USING THE STEAM
FUNCTION)
•
•
•
•
icon (B13) or the
•
•
•
icons (B7) and
•
16
sing the icons (B7) and (B8).
The progress bar shows the quantity of water
selected.
Press the OK icon (B9) to confirm (or the
ESC icon (B6) to cancel the operation.
Press the ESC icon (B6) (fig. 18) twice to exit
the menu.
The appliance is now reprogrammed with the
new settings and is ready.
Turn the cappuccino maker towards the centre
(fig. 5).
Take a container, fill it with about 100 g of milk
for each cappuccino to be made and place it
under the cappuccino maker. In choosing the
size of the recipient, bear in mind that the milk
doubles or triples in volume. You are recom-
mended to use partially skimmed milk at refri-
gerator temperature.
Press the icon (B12) (fig. 22). "STEAM
PRESS OK" is displayed.
Press the OK icon (B9).
To interrupt steam delivery, press the
(B12) again or the ESC icon (B6).
Immerse the cappuccino maker in the milk con-
tainer (fig. 23), taking care not to immerse it for
more than half its length.
Press the icon (B12) (take care to avoid
scalds) and press the OK icon (B9).
Steam comes out of the cappuccino maker.
For a creamier froth, immerse the cappuccino
maker in the milk and move the container with
slow upward movements.
You should not deliver steam for more than 2
minutes at a time.
When the required temperature is reached, in-
terrupt steam delivery by pressing the
(B12) again or the ESC icon (B6).
Make the coffee as described above using suf-
ficiently large cups, then fill them with the fro-
thed milk prepared previously.
GB
icon
icon