Care And Cleaning; Cleaning The Filters; Cleaning The Spray Arm; External Cleaning - Electrolux ESF2300 User Manual

9. CARE AND CLEANING

WARNING!
Before maintenance, deactivate
the appliance and disconnect the
mains plug from the mains socket.

9.1 Cleaning the filters

9.2 Cleaning the spray arm

9.3 External cleaning

Clean the appliance with a moist soft
cloth.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
A
B
Dirty filters and clogged spray arm
decrease the washing results.
Make a check regularly and, if
necessary, clean them.
1. Turn the filter (A) counterclock-
wise and remove it.
2. Remove the filter (B).
3. Wash the filters with water.
4. Put the filter (B) to its initial po-
sition.
5. Put the filter (A) into position in
filter (B). Turn it clockwise until
it locks.
An incorrect position of the
filters can cause bad
washing results and dam-
age to the appliance.
1. Turn the nut counterclockwise.
2.
Remove the spray arm.
3. Clean the holes.
If the holes in the spray arm are clogged,
remove remaining parts of soil with a thin
pointed object.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
•
- The appliance does not drain the
water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
ENGLISH 53