Cisco SPA Phones User Manual page 16

14 Cisco SPA Phones User Guide
- Example for Hostname: tftp://voip.bicomsystems.com/$MA.cfg
- Example for IP Address: tftp://192.168.1.10/$MA.cfg
Make sure you replace Hostname or IP Address from this example with your
PBXware Hostname or IP address.
Click on Submit All Changes and wait 35 seconds. The phone may reboot.
Reboot the phone and wait for the phone to reboot once again.
Auto provisioning process will start during phone reboot process, phone will pickup
appropriate configuration file from PBXware. If everything is done as above
described, you should have successfully registered your phone to PBXware. Dial
*123 to verify registration.
4.2.3.2.2 HTTP & HTTPS
This chapter describes how to use HTTP & HTTPS protocols in order to register Cisco
SPA phone.
Contact your PBXware administrator. Bicom Sy stem s can prov ide serv ice to set up this
for y ou.
In the Profile Rule field enter http:// or https:// followed by Hostname or IP
Address, followed then by /tftp/
- Example for Hostname using HTTP: http://voip.bicomsystems.com/tftp/
- Example for Hostname using HTTPS: https://voip.bicomsystems.com/
tftp/
- Example for IP Address using HTTP: http://192.168.1.10/tftp/
- Example for IP Address USING HTTPS: https://192.168.1.10/tftp/
Make sure you replace Hostname or IP Address from this example with your
PBXware Hostname or IP address.
Click on Submit All Changes and wait 35 seconds. The phone may reboot.
Reboot the phone and wait for the phone to reboot once again.
Auto provisioning process will start during phone reboot process, phone will pickup
appropriate configuration file from PBXware. If everything is done as above
N O TE Y our PBX ware needs to be configured correctly for this to work.
© 2003 - 2012 Bicom Systems