Denon DN-F650R Owner's Manual page 37

Sending the status information for a status request command from the host
w
When DN-F650R receives a status request command from the host, the unit responds with an ACK
command and the status information.
DN-F650R
Status information command
Handshake flow charts for status request command
When DN-F650R receives data other than the specified commands or an End Character (0x0D) without a
Start Character ('@'), a reception error occurs and the unit ends a NACK command.
For "Status request and status information code table", see vpage 35.
Automatically sending the status information when there is a change to the
e
DN-F650R status
When there is a change to the DN-F650R status, the recording or playback file is switched, or there is
a change to the recording media status or setting conditions, DN-F650R automatically sends the status
information to the host.
Host
Status request command
The commands used for sending status information are the same as the status information commands
used for w.
For "Status request and status information code table", see page vpage 35.
DN-F650R
Status command
Handshake flow charts for status command
RS232C control
Host
ACK
29